Sanyo PLC-WXU700 - Lamp Replacement

67
Maintenance and Cleaning
Whentheprojectionlampoftheprojectorreachesitsend
oflife,theLampreplacementiconappearsonthescreen
andLAMPREPLACEindicatorlightsyellow.Replacethe
lampwithanewonepromptly.ThetimingwhentheLAMP
REPLACEindicatorshouldlightisdependingonthelamp
mode.
Forcontinuedsafety,replacewithalampofthe
sametype.Donotdropalamportouchaglass
bulb!Theglasscanshatterandmaycauseinjury.
Allowaprojectortocoolforatleast45minutes
beforeyouopentheLampCover.Theinsideof
theprojectorcanbecomeveryhot.
CAUTION
Lamp Replacement
CAUTION
Top Control
LAMP REPLACE
indicator
Lampreplacementicon
ORDER REPLACEMENT LAMP
Replacementlampcanbeorderedthroughyourdealer.Whenorderingaprojectionlamp,givethefollowing
informationtothedealer.
 ● Model No. of your projector : PLC-WXU700
 ●  Replacement Lamp Type No. : POA-LMP111
(Service Parts No. 610 333 9740)
Followthesestepstoreplacethelamp.
TurnofftheprojectorandunplugtheACpowercord.
Lettheprojectorcoolforatleast45minutes.
Loosenthetwo(2)screwsthatsecurethelamp.Lift
thelampoutoftheprojectorbyusingthehandle.
1
3
Replacethelampwithanewoneandsecurethetwo
(2)screws.Makesurethatthelampissetproperly.
Closethelampcoverandsecurethescrew.
4
Removethescrewandopenthelampcover.
2
ConnecttheACpowercordtotheprojectorandturn
ontheprojector.
6
Reset the lamp counter.
See“ResettingtheLampCounter”onthenextpage.
5
Handle
Screw
LampCover
Presshereandpullupward.
Screw
Lamp
Screw
WARNING:
TURNOFFTHEUVLAMPBEFORE
OPENINGTHELAMPCOVER
Note:
TheLampreplacementiconwillnotappearwhentheDisplayfunction
issettoOff(p.49),during"Freeze"(p.28),or"Noshow"(p.29).