Sanyo PLC-WXU700 - Connecting the AC Power Cord

20
Installation
Connecting the AC Power Cord
Thisprojectorusesnominalinputvoltagesof100-120Vor
200–240VACanditautomaticallyselectsthecorrectinput
voltage.Itisdesignedtoworkwithsingle-phasepower
systemshavingagroundedneutralconductor.Toreduce
theriskofelectricalshock,donotplugintoanyothertypeof
powersystem.
Ifyouarenotsureofthetypeofpowerbeingsupplied,
consultyourauthorizeddealerorservicestation.
Connecttheprojectorwithallperipheralequipmentbefore
turningtheprojectoron.
Note:
UnplugtheACpowercordwhentheprojectorisnot
inuse.Whenthisprojectorisconnectedtoanoutlet
withtheACpowercord,itisinStand-bymodeand
consumesalittleelectricpower.
ConnecttheACpowercord(supplied)tothe
projector.
TotheACoutlet.
(200 - 240 V AC)
NOTE ON THE POWER CORD
ACpowercordmustmeetrequirementofthecountrywhereyouusetheprojector.
ConfirmtheACplugtypewiththechartbelowandproperACpowercordmustbeused.
IfsuppliedACpowercorddoesnotmatchyourACoutlet,contactyoursalesdealer.
Topowercord
connectoronyour
projector.
Projector side
AC outlet side
Ground
TotheACoutlet.
(120 V AC)
For the U.S.A. and Canada
TotheACoutlet.
(200 - 240 V AC)
For the U.K.For Continental Europe

CAUTION
TheACoutletmustbenearthisequipmentandmustbe
easilyaccessible.