Sanyo PLC-WXU700 - Laser Pointer Function; Pointer Function

14
Part Names and Functions
Spotlight
Pointer Function
Pointer
Laser Pointer Function
LASERbutton
PRESENTATIONPOINTER
button
Thisremotecontrolemitsalaserbeamfromthelaserlightwindow.PresstheLASERbuttontoactivatethe
laserpointer.Thesignalemissionindicatorlightsredandtheredlaserbeamisemitted.IftheLASERbuttonis
pressedformorethanoneminuteorifitisreleased,thelaserlightgoesoff.
ThelaseremittedisaClassIIlaser.Donotlookintothelaserlightwindoworpointthelaserbeamatyourselfor
otherpeople.Thefollowingisthecautionlabelforthelaserbeam.
CAUTION: Useofcontrols,adjustmentsorperformanceofproceduresotherthanthosespecifiedhereinmay
resultinhazardousradiationexposure.Neverlookdirectlyintothelaserlightwindowwhilealaser
isemitted,otherwiseeyedamagemayresult.
Thecautionlabelisputontheremotecontrol.
YoucanmovetheSpotlightorPointeroftheprojectorwiththeremotecontroltoemphasizeapartofthe
projectedimage.
PressandholdtheMENUandtheNOSHOWbuttons
formorethan5secondstoactivatethePointerfunction.
(TheLaserpointerhasswitchedtothePointerfunction.)
1
PresstheLASERbuttonontheremotecontrolpointing
towardtheprojector.TheSpotlightorPointeris
displayedonthescreenwiththeLASERbuttonlighting
green.ThenmovetheSpotlightorPointerwiththe
PRESENTATIONPOINTERbutton.IftheLASERbutton
doesnotlightgreenandcontinuestoemitalaserbeam,
trytheabovementionedprocedureuntiltheLASER
buttonlightsgreen.
2
TocleartheSpotlightorPointeroutthescreen,press
theLASERbuttonpointingtowardtheprojectorandsee
iftheLASERbuttonlightingisturnedoff.
ToswitchtotheLaserpointeragain,pressandholdthe
NOSHOWandMENUbuttonsformorethan5seconds
orslidetheRESET/ON/ALL-OFFswitchtoRESETand
thentoON.
WhenyouresetthePointerfunction,theremotecontrol
codewillbereset,aswell.
3
Note:
 YoucanchoosethesizeofSpotlight(Large/Middle/
Small)andthepatternofPointer(Arrow/Finger/Dot)in
theSettingMenu.See“Pointer”onpage54.
AftertheLaserpointerhas
switchedtothePointer,use
theLASERbuttonasthe
PointerfunctionON-OFF
switch.PresstheLASER
buttonpointingtowardthe
projectorandseeifitlights
green.
LaserLightWindow
SignalEmissionIndicator
MENUbutton
NOSHOWbutton
PressandholdtheMENU
andNOSHOWbuttonsfor
morethan5seconds.
PRESENTATIONPOINTER
button