Sanyo PLC-WXU700 - Input Source Selection (Component, RGB Scart 21-Pin,Hdmi)

41
Video Input
ChooseComputer 1 bypressingtheINPUTbuttononthetopcontrolorpresstheCOMPUTERbuttononthe
remotecontrol;chooseHDMIbypressingtheINPUTbuttononthetopcontrolorpresstheHDMIbuttononthe
remotecontrol.
Before using these buttons, correct input source should be selected through Menu operation as described
below.
1
Input Menu
2
UsethePoint▲▼buttonstoselectComputer 1and
thenpressthePoint►button;usethePoint▲▼
buttonstoselectHDMI,andthenpresstheSELECT
button.
Input Source Selection (Component, RGB Scart 21-pin, HDMI)
Whentheinputsourceiscomingfromvideo
equipmentconnectedtotheCOMPUTER
IN1/COMPONENTINterminalwitha
Component-VGACable,selectComponent.
Component
Whentheinputsourceiscomingfromvideo
equipmentconnectedtotheCOMPUTER
IN1/COMPONENTINterminalwithaScart-
VGACable,selectRGB (Scart).
RGB (Scart)
Direct Operation
Menu Operation
PresstheMENUbuttontodisplaytheOn-Screen
Menu.UsethePoint▲▼buttonstoselectInputand
thenpressthePoint►ortheSELECTbutton.
Note:

 •NetworkisfortheNetworkfunction.Seetheowner’s
manualof“NetworkSet-upandOperation”.
 •WhentheInputSearchfunctionissetto
On1orOn2,
theinputsignalwillbesearchedautomatically(p.48).
COMPUTER button
Top Control
INPUT button
Remote Control
3
WhenComputer 1isselected,usethePoint▲▼
buttonstoselectComponentorRGB(Scart) andthen
presstheSELECTbutton.
Computer 1
Computer 2

When the video signal is connected to the
HDMIterminal,selectHDMI.
HDMI
HDMI button
HDMI
Computer 1
HDMI
Computer 2

S-video
Network
Video

COMPUTER 2cannotbeselectedwhenusingtheCOMPUTERIN2/
MONITOROUTterminalasMONITOROUToutput.