Sanyo PLC-WXU700 - Page 30

29
Basic Operation
blackout→thecapturedimage→normal→
•••••
PresstheNOSHOWbuttonontheremotecontroltoblackout
theimage.Torestoretonormal,presstheNOSHOWbutton
againorpressanyotherbutton.Whenaprojectedimageis
capturedandsetasUserintheLogoselection(seepage50),
thescreenchangeseachtimeyoupresstheNOSHOWbutton
asfollows.
NO SHOW button
PresstheP-TIMERbuttonontheremotecontrol.TheP-Timer
display00:00appearsonthescreenandthecountdownstarts
(00:00–59:59).
Tostopthecountdown,presstheP-TIMERbutton.Tocancel
theP-Timerfunction,presstheP-TIMERbuttonagain.
P-TIMER button
PresstheIMAGEbuttonontheremotecontroltoselecta
desiredimagemodeofthescreen.Seepages36,43for
details.
IMAGE button
No showdisappearsafter4seconds.
P-Timerdisplay
Note:
 Seethepreviouspageforthedescriptionof
otherbuttons.
IMAGE button
NO SHOW button
P-TIMER button
SCREEN button
Selectthescreensize(Seepages38-39,46fordetails).
SCREEN button