Initial Startup
t Open the locking tabs (2) of the connection adapter with the red label (#2).
Next, press the connection adapter (3) firmly into place on the cover of the
cartridge with the red label (#2). Push the connection adapter so far down
that the locking tabs are located at the level of the spacers.
t Push both locking tabs (4) of the connection adapter with the red label (#2) all
the way under the upper ring of the spacers.
t Place the red-labeled cartridge (#2) in the housing on the right (5).
The label must be facing you.
t Open the locking tabs (2) of the connection adapter with the blue label (#1).
Next, press the connection adapter (3) firmly into place on the cover of the
cartridge with the blue label (#1). Push the connection adapter so far down
that the locking tabs are located at the level of the spacers.
t Push both locking tabs (4) of the connection adapter with the blue label (#1) all
the way under the upper ring of the spacers.
t Place the blue-labeled cartridge (#1) into the housing (6).
The label must be facing you.
t Close the device door.
To Next Page
Loading...
