Initial Startup
4.6 System Rinsing
t Connect the feed water tubing (inlet) to the arium
®
pro system. Use the pre-
assembled tubing from the arium
®
pro accessories. Next, open the feed water
inlet.
Observe the device specifications in Chapter “10. Technical Specifications”!
t Attach the sampling tubing to the dispenser unit.
t Direct sampling tubing towards drain.
t Start the rinsing process.
y The arium
®
pro system is rinsed for 20 minutes. The remaining rinsing time is
shown on the display.
Startup
Connect the feed water
tubing to the device and
open the feed water inlet
OK
Startup
Attach the sampling tubing
to the dispenser unit
OK
Startup
Channel tubing for
dispensing to drain
OK
Startup
Press Start to rinse the
system
Start
Startup
Rinsing
20 min
Cancel
To Next Page
Loading...
