System Menu
6.3.7 Display
Under Menu r Settings r Display, the contrast and brightness of the display
screen can be adapted to your requirements, each in 3 stages.
To change the contrast and | or brightness of the display, select the desired setting.
6.3.8 PIN
This function lets you limit access to the Menu r Settings and the Care modes.
If you have active PIN protection, these two sections can only be accessed by
entering a PIN.
The PIN protection function is located under Menu r Settings r PIN. The factory
setting for PIN protection is deactivated and the standard PIN is set to “0000”.
If you forget your PIN, it can only be reset by a service technician.
6.3.9 Resetting to Default
Under Menu r Settings r Reset to default, you can restore your arium
®
pro
system to default settings. This applies to all settings configured on the system after
initial startup (e.g. Limit values, Display and Acoustic signals, etc.).
The system reboots after connection.
6.4 System Status
Under Menu r System status, information about the following sub-items can be
obtained:
− Device
− Measured values
− Timer
− Service
− Warnings
6.4.1 Device
Under Menu r System status r Device, you can display the following information:
− Model
− Serial number
− Software version
r r Display
Contrast: bright
Brightness: normal
Back
r r PIN
Status: Inactive
Change PIN
Back
r r Reset to default
Restore default settings
Cancel
Menu r System status
Device
Measured values
Timer
Service
r r Device
arium pro
S/N: 09394001
Software V03.00
Back
To Next Page
Loading...
