Operation
5.2.2 Time-controlled Dispensing
t To perform time-controlled dispensing, place an appropriately large vessel
under the sampling outlet and in the operating mode press the (R) “
” key.
t The currently set dispensing time is shown in the display. To change the
dispensing time, select “Set dispensing time”.
t Set the desired dispensing time.
The following dispensing times can be adjusted according to the given scale intervals.
The changed dispensing time (2.5 min in the example) is indicated in the display.
Dispensing time Scale interval
0.5 min – 10 min 0.5 min
10 min – 30 min 1 min
30 min – 60 min 5 min
The adjustable dispensing time depends on the connected arium
®
bagtank.
t Switch to “Time-controlled” and start time-controlled dispensing.
y The remaining dispensing time is indicated in the display.
t Time-controlled dispensing can be canceled by pressing the function key (R)
“
Stop
”. The system then switches back to the operating mode.
The termination of time-controlled dispensing is signaled acoustically via the
confirmation beep (see Chapter “6.3.6 Acoustic Signals”, page 33).
Dispense
Time-controlled
5.0 min
Back
▲ ▼
Dispense
Set dispensing time
2.5 min
▲ ▼
Dispense
Time-controlled
2.5 min
Back
▼ Start
15:32 10.04.15
0.055 µS/cm c
2.0 min
Stop
To Next Page
Loading...
