Initial Startup
4.3 Setting the Date and Time
t Use this option to select the desired date and time format.
t Set date and time.
4.4 Setting Measurement Unit
t You can set the unit in which your measured values should be indicated on the
display.
It is also possible to display the measured value without compensated display.
After startup, the displayed values in the open menu item: Settings r Displayed
values can be changed (see Chapter “6.3.1 Displayed Values”, page 31).
4.5 Purification Component Installation
t Install the cartridges as described in the following instructions.
Ultrapure Water Cartridges Installation
t Remove the new cartridges from the packaging. One cartridge is marked with a
blue label (#1). The other cartridge is marked with a red label (#2). Please write
the date of installation on both cartridges under “Date of Installation”.
t To facilitate the connection of the adapters to the cartridge, don gloves to
moisten the O-rings (1) on the connection adapter with distilled water. Avoid
direct contact with skin at the connections in order to prevent any microbial
contamination.
Set date and time
DD.MM.YY 24 h
MM/DD/YY AM/PM
▼
Set date and time
DD.MM.YY 24 h
10.04.15 11:43
▲ ▼
Set measurement unit
µS/cm comp.
MΩcm comp.
▼
Startup
Install cartridges according
to operating manual
OK
To Next Page
Loading...
