Operation
5.2.3 Ultrapure Water Dispensing Through the Sampling Tubing
Water can also be dispensed through the sampling tubing included with the
equipment supplied. It may be advisable to use the outlet tubing when, for example,
you need to fill a larger vessel.
To connect the tubing, proceed as follows:
t Release the final filter from the quick connector on the display | dispenser unit
by simultaneously pulling out the filter and pressing the retaining ring on the
component.
t Press the sampling tubing onto the quick connector of the display | dispenser
unit.
t Attach the straight connector to the free end of the sampling tubing.
t Press the final filter into the straight connector.
t Allow 6 liters of water to run through the final filter (e.g. using manual and | or
volume-controlled water dispensing); this is done to rinse the final filter.
t Vent the final filter using the attached vent valve.
t After dispensing ultrapure water, attach the protective cap to the bell assembly.
The rinsing of the final filter can be omitted if no new final filter is used.
To Next Page
Loading...
