Operating the Balance
Warmup Time
After initially connecting the balance to AC power
(or after a relatively long power outage), the balance
will need to warm up for at least 30 minutes.
Turning the Display On and Off (Standby Mode)
Press the e key (14) to turn the display on and off.
Self-Test
After the balance has been turned on, an automatic
self-test of the electronic circuitry will be performed.
The self-test ends with a zero readout; the balance is
then ready to operate.
Important Note Concerning Verified
Balances/Scales Approved for Use as Legal
Measuring Instruments in the EU:
For verified balances that have a verification scale
interval “e” which is greater than the scale interval
“d,” the last digit on the display is bordered.
1–14
To Next Page
Loading...
Need help?
General