Universal Switch for Remote Control
You can connect an external universal switch to the interface of your balance for
remote control of certain functions (listed below). Set the appropriate menu code to
define the function of this switch.
Functions Code
Print * 8 4 1
Tare 8 4 2
f key 8 4 3
F key 8 4 4
Analog Display: Bar Graph/Marker
In the factory setting, the analog display works as a bar graph. By changing
the menu code, you can turn the analog display completely off or have it appear
as a marker. When the marker is selected, two individual segments will move
within the display scale range to indicate the loading status of your balance.
Analog display Code
Off 8 5 1
Bar graph * 8 5 2
Marker 8 5 3
Power-On Mode
Depending on the operating mode, line current, battery operation or continuous
operation, you can change the power-on mode of your balance.
The factory setting is: (power) off –> on <–> standby.
In the setting “toggle between on and (power) off,” the balance remains off after
a power failure has occurred or after the balance has been disconnected from
AC power. After the balance has been turned off, power for the “standby” mode
is not available. In this setting, the balance can be turned on and off using
the e key.
* = factory setting
2–19
To Next Page
Loading...
Need help?
General