0–1
Contents
Page
General Views of the Balances 1– 1
Warranty 1– 6
Storage and Shipping Condtions 1– 6
Installation Instructions 1– 7
Getting Started 1– 9
Connecting the Balance
to AC Power 1–10
Voltage Selection 1–11
Connecting Electronic Devices
(Peripherals) 1–11
Safety Precautions 1–11
Information on Radio Frequency
Interference 1–12
Adjusting the Display Unit 1–12
Information on Weighing Electro-
statically Charged Samples 1–12
Leveling the Balance Using
the Level Indicator 1–13
Operating the Balance 1–14
Warmup Time 1–14
Turning the Display On and Off 1–14
Self-Test 1–14
Taring 1–16
Weighing 1–16
Weighing Range Structure 1–17
Weighing in the IQ-Mode
(Load-Dependent Readability) 1–18
Calibration 1–19
Sensitivity Test 1–23
Data Interface 1–25
Below-Balance Weighing 1–27
Fastening an
Antitheft Locking Device 1–27
Troubleshooting Guide 1–28
Care and Maintenance 1–30
Manufacturer’s Declaration 1–32
Page
Balance Operating Menu 2– 1
Changing a Menu Code Setting 2– 2
Undoing All Menu Code
Changes: Reset Function 2– 4
Balance Operating Parameters 2– 5
Adapting the Balance
to Ambient Conditions 2– 5
Standard Weighing Mode –
Manual Filling Mode 2– 5
Stability Range 2– 5
Stability Symbol Delay 2– 6
Tare Parameter 2– 6
Auto Zero Function 2– 6
Weighing in Three Ranges
on Standard Balances 2– 7
Selecting the Number
of Ranges 2– 7
Weight Units 2– 7
Weighing in Two Ranges
on Verified Balances 2– 9
Selecting the Number
of Ranges 2– 9
Weight Units 2– 9
Display Modes on
Standard Balances 2–10
Final Readout Mode 2–10
Last Numeral Blanked When
the Load Changes 2–10
Round-Off Function 2–10
IQ-Mode 2–10
PolyRange Function 2–11
Display Modes on
Verified Balances 2–12
Calibration Functions on
Standard Balances 2–13
To Next Page
Loading...
Need help?
General