Control Commands with Upper-Case Letters or Special Characters
Print
Acoustic signal
Self-test
Tare
Internal calibration*
The P, Q, T and Z commands do not affect the code settings of the balance
operating menu. The S command causes the processor to reinitialize (turns the
balance off and back on again).
The balance will operate according to the commands available up until the
processor is reinitialized. Once the balance has been turned on, the processor will
always recognize the codes entered by the user in the balance operating menu.
Block keypad
Release keypad
Adaptation to Ambient Conditions
Very stable
Stable
Unstable
Very unstable
* = only on balances with a built-in, automatic calibration weight
ESC N CR LF
ESC M CR LF
ESC L CR LF
ESC K CR LF
ESC R CR LF
ESC O CR LF
ESC Z CR LF
ESC T CR LF
ESC S CR LF
ESC Q CR LF
ESC P CR LF
5–7
To Next Page
Loading...
Need help?
General