Special Interface Functions
Data Input/Output to/from the Female Interface Connector
You can plug an external switch for remote control into the female interface
connector (such as foot switch YPE 01RC with the three functions ”open/close
draft shield,” ”tare” and “print” [factory setting]).
If you change the menu code setting, you can interface both a checkweighing
display (such as our color-coded YRD11Z for OVER/UNDER checkweighing)
and our universal remote-control switch to your balance.
Pin assignment for the female interface connector:
Pin Function “Inputs” Function “Outputs”
(Code 8 7 2) (Code 8 7 1)
15 Print “Universal switch” (see below)
16 Open/close draft shield Control output 1: lighter
17 f key Control output 2: equal
18 F key Control output 3: heavier
19 Tare Control output 4: “set” (target)
External, Universal Remote-Control Switch (only with Code 8 7 1)
You can plug an external, universal remote-control switch into the interface port
on the balance.
To change the function of this switch, set the appropriate menu code listed below.
* = factory setting; depends on the balance model in some cases
Functions Code
Print 8 4 1
Tare 8 4 2
f key 8 4 3
F key 8 4 4
Open/close draft shield * 8 4 5
Interface Function Code
Outputs * 8 7 1
Inputs * 8 7 2
4–17
To Next Page
Loading...
