Getting Started
MC 210 S, MC 210 P and MC 410 S (-0CE):
Place the components listed below inside the
weighing
chamber one at a time in the order given:
– Shield disk (8)
– Weighing pan (7)
– Protective ring (6)
– Interior weighing chamber draft shield (5)
(only on MC 210 S, MC 210 P (-0CE))
– Place the small draft shield cover (2) on top of the
semicylindrical interior draft shield door (4).
Then place the large draft shield cover (1) on top
of the semicylindrical exterior draft shield element (3).
Secure the draft shield cover in place using the
fastener (see arrow).
Important Note Concerning Verified Balances
Approved for Use as Legal Measuring Instruments:
Provided that an official lead seal is required for the
verified balance, a control seal is affixed to the
balance. Unauthorized attempts to remove this seal
will irreversibly damage it. If you break the seal,
the validity of the verification will become void, and
you must have your balance subsequently verified.
1–10
To Next Page
Loading...
Need help?
General