Weighing Sequence
Individual or Combined Weighing Mode
Individual Weighing Mode
In the individual weighing mode, the weights are stored in the following sequence:
– Tare weighing – weighing-in – backweighing
– If necessary, selection of an available memory location
– Tare weighing – weighing-in – backweighing...
The data of a sample in a memory location are overwritten until a new memory
location is selected.
In the consecutive individual weighing mode, the weights are stored in this sequence:
– Tare weighing – weighing-in – backweighing
– Automatic selection of the next memory location
– Tare weighing – weighing-in – backweighing...
Beginning at a specific memory location, the memory locations that follow
are selected automatically using the F key. It is also possible to switch to a new
memory location using the numeric keys and the F key.
Combined Weighing Mode
In the combined weighing mode, the values are stored in the following sequence:
– Tare weighing – weighing-in – tare weighing – weighing-in...
Backweighing is done only after all of these operations have been completed.
To Next Page
Loading...
