1. Double click on the file partition with the left mouse
button.
2. Select a partition type for your file.
3. Select the number of parameters you want to be recorded
in the file records.
4. Select the maximum number of records you want to be
recorded in the file.
5. Click OK, and then send your new setup to the meter, or
save to the device database.
6. Highlight the data log file row with the left mouse button,
and then click on the “Setup Recorder” button, or click on
the “Data Recorder” tab and select the log number
corresponding to your file.
7. Configure the list of parameters to be recorded in your
data log file. You are not allowed to select more
parameters than you defined when configuring your file.
Refer to Appendix D for a list of available parameters.
For your convenience, PAS will follow your selection and
help you to configure a series of the neighboring
parameters: when you open the “Group” box for the next
parameter, PAS highlights the same group as in your
previous selection; if you select this group again, PAS will
To Next Page
Loading...
Need help?
General
