SATO HT200e - Process for Ascii Dump on Screen

SECTION 7: OTHERS
SATO HT200e Page 7-7
PROCESS FOR ASCII DUMP ON SCREEN
ＦＯＲＭＡＴ Ｎｏ ．
1〔
・ ・〕
ＨＴ２００ｅ
2【
Ａ ＳＣ ＤＵＭＰ ＭＯＤＥ 】
E
n
t
er
“72”
, an
d
press
[ENTR]
.
Data (STX to ETX) received will be printed in ASCII.
Note 1: Power should be “OFF” when on-line mode
is canceled.
Note 2: Data between STX (02H) to ETX (03H) are
made only available for the ASCII dump.
Note 3: Maximum No. of characters to be printed
will be 754.
Note 4: A P51mm x W48mm label is only available.
Note 5: Press [FEED], so that one blank label will be
carried.
[A sample of print
on ASCII dump]
[A sample of print]