SECTION 2: INSTALLATION AND SETUP
Page 2-36 SATO HT200e
OTHER SETTING
THE SCREEN FOR DISCOUNT RATE SETTING
Note 1) Discount rate is a prerequisite, so that 0% can not be allowed.
Note 2) Where asterisk mark or “*” can be seen in the upper right on the screen, entry by scanner can be made
possible.
Note 3) Fractions should be omitted.
SCREEN FOR EURO CURRENCY CONVERSION RATE SETTING
For the entry of conversion rate, enter within 6 digits (Max.) without decimal points. In addition, C should be
０．
１
or more for this entry.
For setting conversion, the rate determined should be entered
e.g.) 1.95583 (Germany)
1234
．
567890
(This entry is not VALID.)
Note 1: After four places of decimal will not be printed for the result of calculation.
(Three places of decimal will be rounded off.)
Note 2: For the calculation of the currency mark becoming C
, where the result of calculation is rounded off, and
the value before calculation can not be calculated back precisely with the method of the C
becoming the
currency mark.
IMPORTANT 1) Discount rate is a prerequisite, so that 0% can not be allowed.
IMPORTANT 2) Where asterisk mark or “*” can be seen in the upper right on the screen, entry by scanner can
be made possible.
Complimentary note: Dual pricing means that the currency for each country and Euro will be printed in double
price.
［ ＷＡＳ ２５％ ］ *
1￡
・ ・・・・・
ＤＩＳＣＯＵＮＴ ＲＡＴＥ
2［
・ ・］％
［ ＰＲＩＣＥ ］ *
1￡
・ ・・・・・
ＣＯＮＶＥＲＳＩＯＮ ＲＡＴＥ
2 Ｃ１＝［ ００００ ．００００００ ］
On the WAS entry screen for the markdown format
(16, 17, 18, 19, 25), press [FNC2], so that the
discount rate being set will appear on the upper
screen.
Key new discount rate, and press [ENTR] so that it
returns to the process No. 1. Where [AC] is pressed,
the data entered will be cleared.
Conversion rate (a prerequisite) MUST be entered:
Where [ENTR] is pressed, it can be back to the
process No. 1. When [AC] is pressed, the date
entered will be cleared. Note: Where no rate is set,
the process No. 2 will automatically be displayed
before the No. 1.
On the PRICE entry screen for the dual pricing format
(20, 21, 28, 29), press [FNC2].
To Next Page
Loading...
