SECTION 2: INSTALLATION AND SETUP
SATO HT200e Page 2-7
DISCHARGING BATTERY PACK
Continued use of the battery pack will reduce the chargeable volume.
To prevent this, discharge the battery pack about every 20 times of charge.
This will recover the chargeable volume, and will allow the printer to be used for a longer time.
1. After following steps 1 to 4 in "Charging the battery pack", press the DISCHARGE button.
*Pressing the DISCHARGE button will cause the battery charger lamp to flash on and off in green (discharge
for about 8.5 hours). Then the lamp will light up in red (charge for about 2.5 hours).
*The maximum charging time is about 11 hours, though it may vary according to battery conditions.
*After charging, the battery charger lamp will light up in green.
DISCHARGE button
To Next Page
Loading...
