SATO HT200e - Process for Barcode-Retrieved Print on Screen

SECTION 7: OTHERS
SATO HT200e Page 7-15
PROCESS FOR BARCODE-RETRIEVED PRINT ON SCREEN
When printing preset, the screen on the entry of preset No. is used to scan a barcode, and data
identical to requirement will be retrieved from the preset data already registered.
[ENTR]
[ENTR]
[ENTR]
[ENTR]
【 ＰＲＥＳＥＴ 】
1
Ｐ Ｒ Ｉ Ｎ Ｔ ＳＴＲ ＭＯＤＩＦＹ
ＤＥＬ ＤＵＭＰ ＭＡＳＴＥＲ
ＰＲＥＳＥＴ ＮＯ ．ＩＮＰＵＴ *
2
・ ・・・ ＜ＰＲＩＮＴ＞
［ ＩＴＥＭ ］
3
・ ・・・・・・・・
［ ＰＲＩＣＥ ］
4￡
・ ・・・・・
［ ＱＴＹ ］
5
・ ・・・
ＰＲＩＮＴＩＮＧ
6
ＰＲＥＳＥＴ ＮＯ ．ＩＮＰＵＴ *
7
０ ００１ ＜ＰＲＩＮＴ＞
On the screen for the selection of printing preset,
press [ENTR] so that it goes to the screen for the
entry of preset No.
This screen allows you to scan a barcode.
Note: Where free format is used, the field No. 1
should be selected as a barcode field. Note that
print for barcode retrieval is to search preset data
for the field No. 1., so that this is required when
field parameter is established.
You should realize that the contents of data
vary, depending on the format No. called up:
Press [ENTR], while checking data in each
It will start printing for preset:
When finished printing, it goes to the next
procedure.
Enter No. of label within 4 digits and press
[ENTR]. Note: Neither 0 nor un-entry is allowed.
Preset No. for the preset data printed, will be
displayed.