SATO HT200e - Page 40

SECTION 2: INSTALLATION AND SETUP
Page 2-22 SATO HT200e
PROCESS ON THE SCREEN FOR COPY OF PARAMETER
6 + Power “ON”
Or:
In the copy for parameter, copy will be made from a printer to a card and from a card to a printer, for print
parameter, preset, currency mark font, and table data.
Note: Memory card should be set before turning the power “ON”.
ＰＡＲＡＭＥＴＥＲ ＣＯＰＹ
1 ＰＲＩＮＴＥＲ ←→ ＣＡＲＤ
ＰＡＲＡＭＥＴＥＲ ＣＯＰＹ
2
Ｈ Ｔ → Ｃ Ａ Ｒ Ｄ ＣＡＲＤ→ＨＴ
ＨＴ→ＣＡＲＤ ＣＯＰＹ ＯＫ？
Ｙ ／Ｎ
ＣＡＲＤ→ＨＴ ＣＯＰＹ ＯＫ
Ｙ ／Ｎ
ＣＯＰＹＩＮＧ
Press [ENTR], so that it goes to the screen for the
selection of copy.
Move with [
← ] and [ → ], and select the type of.
copy Press [ENTR], so that it goes to the screen
for the confirmation of initiating copy.
Press [ENTR]:
“Y” is to start copying.
“N” is to return to the process No. 1.
When completing copy, it returns to the process
No. 1.