1-4. Setting Up Your Machine
1-4-1. Power Cord
Plug one end of the cord into the back of the machine and the
other end into a standard AC power outlet.
If you turn on the power switch, the machine will display version
and checksum. If there is Service Call number saved by a
service provider, the Call number will be displayed.
1-4-2. Printer
Your SB-9(2000S) has a serial interface port, which allows you to connect the printer to print out counting result.
To connect the printer to the machine, follow the steps below:
1. Make sure that both the SB-9(2000S) and the printer are turned off.
2. Plug the cable of printer into the serial port of SB-9(2000S).
3. Turn on the printer and SB-9(2000S).
CAUTION
In case that another port is used to avoid electrical shock, turn off SB-9(2000S) and turn on
the machine after Port is connected.
To Next Page
Loading...
