Service Manual for WP6 Diesel Engine
12
We can get that required antifreeze additive for -20
o
C is 13.5L
Difference value between -30
o
C and -20
o
C is 4L
For the difference value 4L, another 50% of that is required and necessary, because of before
adding antifreeze additive, a part of coolant must be drained out, and antifreeze additive in this part
of coolant will be drained out too.
So required antifreeze additive is: 4L+50%*4L=6L.
215 Auxiliary Materials
Table 2-1 Auxiliary materials
Molykotte Pulver
(Fine molybdenum powder)
Apply on smooth metallic surface to prevent
occlusion.
For example: Cylinder sleeve external
surface.
Molykotte G.u.plus
(Molybdenum disulfide
oiling agent)
Play lubrication action before lubricating oil
pressure is built-up.
For example: Apply on intake valve rod.
Table 2-2 Reference table for grease application of diesel engine
Application position list
Apply on thread for
fixation and to
prevent loose,
medium strength
Flywheel housing bolt
Camshaft thrust plate bolt
Camshaft timing gear bolt
Middle idle gear bolt
Engine front cover bolt
Engine oil filter seat bolt, engine oil cooler bolt
Plug screw of engine oil cooler regulating valve
Bolt of fuel pump oil return pipe fixing device
Air compressor shaft end thread
Oil strainer bolt
Bolt of sensor and wiring harness fixing device
It is optional
to pre-coat
DriLoc204.
Apply on thread to
lock, seal and
prevent loose
Cylinder cover auxiliary bolt
Anti-loosing and
fastening
Bowl type plug used to block oil hole
To Next Page
Loading...
General