SDLG WP6 - Disassembly, Inspection, Maintenance and Assembly of Front and Rear Oil Seals

Service Manual for WP6 Diesel Engine
53
3372 Steps to Disassemble Thrust Plates
(1) Remove main bearing cap (refer to section 332);
(2) Remove crankshaft (refer to section 344);
(3) Remove thrust plates (key point 1).
3373 Inspection and Maintenance of Thrust Plates
Key point 1:
Assembling:
Thrust plate should be used in pairs and the side with oil groove should be outward during
assembling. Put the anti-misloading lug in corresponding groove of thrust bearing cap.
3374 Steps to Assemble Thrust Plates
Assembling steps are contrary to disassembling ones.
338 Disassembly, Inspection, Maintenance and Assembly of Front and
Rear Oil Seals
3381 Exploded View of Front and Rear Oil Seals
Flywheel housing
Engine front cover
Rear oil seal
Front oil seal
(radial seal ring)
Fig. 3-24 Exploded view of front and rear oil seals