Switching off
The generating set may be stopped at any time by pressing 0 on the test keypad.
Pressing
Stop may cause an interruption in the power supply depending on its status when the button is
pressed (e.g. isolated grid operation).
The generating set will stop after the cooling delay (180 seconds by default).
Important
The green LED underneath the generating set symbol goes out to indicate that the
generating set has stopped.
6.3.8.3. Rental options
Damper valve (Optional)
X If the generating set stops when the valve damper is closed, repair the fault.
Y Display the fault according.
Z Press “Reset” to clear the fault after it has been repaired.
[ If faults persist, repair them.
To Next Page
Loading...
Need help?
General
