During saving, the following screen indicates that the operation in is progress:
6.3.4 Configurations
6.3.4.1. Operating principle
The operational modes are as follows:
SOLO
Genset
Without
coupling to
grid
With coupling
to grid
- Operation of a single genset without coupling.
- Normal/emergency switch (NES) not controlled by Kerys.
Without N/E
switch
(A612)
Temporary
coupling
(A651)
Power plant
Without
coupling to
grid
Without N/E
switch
(A633)
- Automatic operation of a single genset.
- Temporary coupling on grid return following interruption.
Without N/E
switch
(A632)
- Operation of a power plant without coupling to grid.
- Normal/emergency switch (NES) not controlled by Kerys.
- Power plant gensets interconnected by parallel lines.
- Operation of a power plant without coupling to grid.
- Normal/ermegency switch (NES) not controlled by Kerys.
- Power plant genset interconnected by CAN.
Note:
Without coupling: the switch is equipped with electrical and mechanical interlocking.
With coupling: the switch is not equipped with an electrical and mechanical interlock.
Saving in flash…
To Next Page
Loading...
