SEAWARD PRIMETEST SERIES USER MANUAL
TESTED. TRUSTED… WORLD WIDE Page 60 of 77
Select the required test using either the number keys, the function keys or the arrow keys and use the
Accept (F4)
F2 selects the socket test that checks the supply socket.
F3 selects the Checkbox test sequence (PrimeTest Elite+ only)
Use Tools (F3) To view / edit / configure the test settings of a Manual Test, where appropriate, you
can change the test duration, test pass / fail limit or test type / connection. Once the required
parameters have been changed select Save F4 on that screen.
The test leads can be nulled prior to testing – this applies when performing Continuity tests so the
resistance of the leads are not included in the final resistance value.
Where appropriate, to perform the test press the green Start button on the instrument.
Always ensure that you have selected the correct test connection method in the test for the probe
connections made.
Please refer to Test Functions, section 13, for specific information about each test type.
To Next Page
Loading...
Need help?
General
