BASIC
- 33 -
8.
PROGRAMMING & MEASUREMENT
Basic is an open system.
Through configuration, select « PROGRAMMING » to modify a preset analysis method or to create a
new one.
Programmable parameters are:
− suction volume,
− temperature,
− unit
− accuracy,
− calculation mode,
− analysis mode
− time (lag time, interval time and number of intervals),
− wavelength,
− linearity limit,
− normal range (high/low)
− check frequency,
− reset/storage
NOTE: At any case, arbitrary values are labeled by small arrows on the right or the left side of the
value.
8.1.
PROGRAM KEYS
To program an analysis test, simply return to set-up procedure: « CONFIGURATION », then
« PROGRAM » and « MODIFY »:
To pass from one analysis mode to another, presses up or down arrow key of the keyboard of the
analysis panel.
Primary position Secondary position
Select one of the program key to place the new test method.
To Next Page
Loading...
