BASIC
- 35 -
NOTE: On work organization, it is advised to run all test methods using the same temperature in one
session to avoid warm-up delay. For your convenience, the cell-holder will remain on the last
temperature used.
NOTE: During warm-up, the programmed temperature digits will blink, rather fast at first, slowing down
afterwards. It takes 15 minutes to stabilize the cell-holder and cuvette to 37°C.
8.5.
UNITS PROGRAMMING
Choose measuring unit according to the recommendation of the reagent technical sheet.
8.6.
RESULTS RESOLUTION (DECIMALS) PROGRAMMING
Concentration result is given by the number of decimals programmed.
Select the digit number after comma
8.7.
CALCULATION MODE PROGRAMMING
A choice of three calculation modes is proposed:
To Next Page
Loading...
