BASIC
- 36 -
Factor: in Kinetic mode, enzymatic factor (coefficient) value is used instead of calibration factor. Enter
factor value indicated on the reagent technical sheet (DELete, and then enter numbers). Results will
be calculated using this factor.
Linear: In End-point, End-point with blank and Two-points-kinetics analysis modes, calibration is
needed (which means, the calculation is done using standard(s)). Enter standard(s) value(s) (DELete,
and then enter numbers).
Non-linear: E.I.A tube methods use this calculation mode (polynomial, log/logit, spline, multi-points).
Enter the number of standards used, then the values of each. Up to 6 standards can be used.
To Next Page
Loading...
