BASIC
- 44 -
8.15.
ERROR MESSAGES
Sample absorbance value is superior to 2,5 (above the reading limit of BASIC) : in this case
the software will show « -,--- ». Check any possible manipulation errors : the sample not
prepared correctly or the cleanliness of the cuvette.
The result in Concentration is superior or inferior to the normal (high or low) value. In this case,
a sign « < » or « > » will be displayed following the result. Negative Concentration value will be
indicated by the sign −.
The result in Concentration is no longer in the linearity limit of the analysis : another sign « < »
shows up in front of the result (in this case the result is also beyond the normal high or low
range).
To Next Page
Loading...
