BASIC
- 45 -
Non executed quality control procedure will be signaled by « Q».
During decreasing kinetics method, if the difference of Optical Density between the initial O.D.
at T0 and at T1 (end of the latent time) is superior to the depletion limit, the software does not
display any result.
If the initial O.D. value of the blank is superior or inferior to the limit , a warning sign appears
following the concentration result.
If the Quality Control value is beyond the specified limit, the sign « » appears in front of
the Concentration result.
In case of Peltier failure Tsign appears instead of the temperature programmed.
To Next Page
Loading...
