Segway SNARLER SGW570A6 2021 - Water Pump Cover Installation

ENGINE-COOLING SYSTEM
ENGINE-COOLING SYSTEM
3-4-10
A
A
B
B
◆
Clean the sliding surface of a new mechanical seal
with a high flash-point solvent, and apply a little
coolant to the sliding surface to give the mechanical
seal initial lubrication.
◆
Apply coolant to the surfaces of the rubber seal and
sealing seat
【
A
】
, and press the rubber seal
【
B
】
and sealing seat into the impeller by hand until the
seat bottoms out.
◆
install the Gasket
【
C
】
◆
Tighten the water pump impeller by turning the bolt
【
D
】
clockwise.
Torque
Water PumpImpeller
9.8 N•m (1.0kgf•m, 87 in•lb)
Water Pump Cover Installation
Water Pump Cover Installation
◆
Install the new water pump cover Gasket
【
E
】
to the
sealing groove of the water pump cover
【
F
】
◆
water pump cover Bolts and Gasket
【
G
】
◆
Tighten
Torque
Water Pump Cover Bolts
9.8 N•m (1.0kgf•m, 87 in•lb)
C
C
D
D
E
E
G
G
F
F