ENGINE-ELECTRICAL SYSTEM
3-3-7
A
B
C
Alternator Rotor Removal
◆
Remove:
1. Alternator Cover (see Alternator Cover Removal)
2. Alternator rotor Nut M18×1.5
【
A
】
3. Thread the flywheel puller
【
B
】
onto the alternator
rotor.
Special Tool - Flywheel Puller
Special Tool - Flywheel Puller
:
E01GZ0010001
Flywheel Holder
:
E01GZ0050001
◆
Holding the
Flywheel Holder
【
B
】
, turn the rotor
puller
【
C
】
until the alternator rotor is forced off the
end of the crankshaft.
CAUTION
If the rotor is difficult to remove, turn the puller while
tapping the end of the puller. Do not strike the alternator
rotor. Striking the rotor can cause the magnets to lose
magnetism.
To Next Page
Loading...
