Segway SNARLER SGW570A6 2021 - Remove; Voltage Regulating Rectifi er Inspection

ELECTRICAL SYSTEM
14 - 14
Voltage regulating rectifi er inspection
Test and Judgment Method of Charging Voltage on Whole Vehicle
Test conditions and methods Output voltage
1. Connect the product according to the normal loading
state, after the vehicle started, the speed will remain
above 2000rpm;
2. Bring a fully charged battery;
3. Use a multimeter to test the voltage at the output
terminal of the regulator
Output voltage:14.0-15.0V
Qualifi ed; otherwise unqualifi ed
Remove
◆ Connector【A】（Disconnect）
◆ Bolt【B】and Voltage regulating
rectifi er【C】
See the table below for the determination
method of the voltage regulating rectifier
resistance:
Output resistance characteristics（unit Ω）
Output + Y1 Y2 Y3 Output-
Digital multimeter
(Diode gear)
Output+
∞ ∞ ∞ ∞
Connect the red pen to output +, and the
black test pen to measure the remaining
terminals
Y1 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y1, and the
black test pen to measure the remaining
terminals
Y2 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y2, and the
black test pen to measure the remaining
terminals
Y3 0.12-0.25
∞ ∞ ∞
Connect the red pen to Y3, and the
black test pen to measure the remaining
terminals
Output- 0.5-0.7 0.4-0.6 0.4-0.6 0.4-0.6
Connect the red pen to output -, and the
black test pen to measure the remaining
terminals
Output resistance characteristics（unit Ω）
A
B
C
B