ELECTRICAL SYSTEM
14 - 58
Power lock
!
When the indicator does not display after the key is
turned on, check the circuit failure (see page xx), and
replace the power lock after confi rming that the power
lock is broken
→ Check Power lock
After unplugging the connector, turn the multimeter
to the conduction position. When the key is turned to
the OFF position, the two wires should not be able to
conduct; when the key is turned to the ON position, the
two wires should be able to conduct;
When you need to replace the power lock, first remove
the seat cushion and fuel tank guard （see "vehicle body
and frame"）.
【
A
】
M6 bolt
【B】power lock
【C】connector
◆
Remove the two M6 bolts
◆ Unplug the connector ,remove the power lock
A
B
A
C
Switch
To Next Page
Loading...
