Segway SNARLER SGW570A6 2021 - Charging System

ENGINE-ELECTRICAL SYSTEM
ENGINE-ELECTRICAL SYSTEM
3-3-6
Alternator Cover Removal
Alternator Cover Removal
◆
Place an coolant pan under the engine left side.
◆
Drain the coolant (see Cooling System chapter).
◆
Place an oil pan under the engine left side.
◆
Remove Water Pump (see Cooling System chapter).
◆
Remove:
Alternator and Crankshaft Sensor Lead Connectors
(disconnect)
【
A
】
Bolts M6×30 (12)
【
B
】
Bolts M6×55 (2)
【
C
】
Alternator Cover
Alternator Cover Installation
Alternator Cover Installation
◆
Be sure all of the old gasket has been removed from
the alternator cover and the left crankcase sealing
surfaces.
◆
Check that the Dowel Pins
【
D
】
are in place, and fi t
a new gasket
【
E
】
on the crankcase.
◆
Fit the grommets
【
C
】
into the notch in the cover.
◆
Install the Alternator Cover bolts
【
A
】
and
【
B
】
◆
Tighten
Torque
Alternator Cover Bolts
9.8 N·m (1.0kgf·m, 87 in·lb)
◆
Install Water Pump (see Cooling System chapter).
A
A
A
A
C
C
B
B
F
F
D
D
E
E
B
B
Charging System