ELECTRICAL SYSTEM
14 - 9
In the case shown in the following table, to start the vehicle fully to start the engine, and it should be
charged before use. However, if the battery voltage is higher than 12.6V after 10 minutes of charging,
no initial charge is required.
The conditions under which an initial charge is required charging method
At low temperatures (below 0℃ )
1.4 A x 2 _ 3 Hours
Batteries have been stored at high temperatures and in high
humidity
1.4 A x 15 _ 20 Hours
The seal has been removed or cracked - fl aked, torn or torn
The battery life is more than 2 years after manufacture
NOTE: Terminal voltage - To measure the terminal voltage of the battery, use a digital voltmeter.
When measuring the terminal voltage after charging, the battery should stand still for more
than 20 minutes.
Preventive measures:
1）Colloidal battery, no liquid fi lling is required
◆ Before normal use, there is no need to replenish the battery as long as it is not exhausted. It is very
dangerous to pry open the sealing plug and add water. Never do that.
2）Recharge
◆ If the engine fails to start, the horn becomes weaker or the indicator light goes dark, it shows the
battery is exhausted.
◆ Charge the battery for 5 to 10 hours according to the charging current as shown in the
specifi cation.
◆
When it is inevitable to need quick charging, please charge in strict accordance with the maximum
charging current and the time conditions indicated on the battery.
Battery charging
To Next Page
Loading...
