FRONT & REAR SUSPENSION
9 - 8
Absorber inspection
Because the front shock absorber is a sealed unit, it
cannot be disassembled, only external inspection is
required. If one unit is damaged, replace two shock
absorbers together as a set. If only one unit is replaced,
when the two shock absorbers are out of balance, it may
cause the vehicle to become unstable at high speeds or
deteriorate the overall comfort.
Normal hydraulic damping absorber
preloading adjustment
【
A
】
The spring adjustment sleeve of the hydraulic
shock absorber【A】There are 5 adjustment positions,
the spring can be adjusted according to diff erent terrain
and loading conditions, if you feel too soft and too hard, it
can be adjusted by the spring table adjustment.
Spring adjustment table
Gear Spring Environment Load Terrain Speed
1
Soft
↓
Hard
Soft
↑
↓
Hard
Light
↑
↓
Heavy
Flat
↑
↓
Bumpy
Low
↑
↓
High
2
（
STD
）
3
4
5
◆
Turn the adjustment sleeve on the shock absorber to
the required gear position with a tool.
Air damping absorber preload adjustment
【B】Hook wrench
◆ The spring adjustment nut of shock is on the upper
end of spring, and use the tool【B】to loosen the
lock nut. Then turn the adjustment nut to loosen.
Shock absorber
A
B
To Next Page
Loading...
