Segway SNARLER SGW570A6 2021 - Page 171

CVT SYSTEM
CVT SYSTEM
3-6-20
4. Align the match–marks on the sheaves, made when
disassembled, and the openings
【
A
】
and grooves
【
B
】
will be matched easily.
5. Install the guide bar of the spring holder set
【
C
】
into
the Dirven Pulley Guide Seat Assembly
【
D
】
.
Special Tool -
Spring Holder Set
:
E01GZ0050001
6. Put the Driven Pulley
【
E
】
onto the Dirven Fixed
Shaft
【
D
】
of the Dirven Pulley Guide Seat Assembly
7. Tighten the Bolt
【
G
】
, and compress the spring with
the spring holder
【
F
】
.
8. Install the circlip
【
H
】
with the circlip pliers.
Special Tool - Circlip Pliers : E01GZ0060001
9. Remove the driven pulley from the spring holder set.
10. Clean the surface of the sheaves with an oil-less
cleaning fl uid.
A
A
B
B
C
C
D
D
G
G
H
H
E
E
F
F