FRONT & REAR SUSPENSION
9 - 15
Hub bearing replacement
If the hub bearing in the knuckle assembly and rear axle
support assembly is damaged, it needs to be replaced.
【A】Take out the split ring with the circlip pliers
【B】Press out hub bearing
【C】Front knuckle
【D】Rear axle mount
Dedicated tool：Circlip plier, Bearing drive kit
Disassembly of rear axle support assembly
【A】Buff er sleeve
【B】Hub bearing
【C】Split ring
【D】Axle support liner
【E】Straight type grease cup (grease fi tting)
Dedicated tool：Circlip plier, Bearing drive kit
!
Check the buffer sleeve
【
A
】
, If the inner hole is
seriously worn, it needs to be replaced, and the grease
should be refi lled after assembly.
To Next Page
Loading...
