STEERING SYSTEM
12 - 4
A
B
!
Do not remove the dust cover, it is full of grease.
Steering rod end installation:
Make sure the sealing ring【B】 is on the rod 【A】.
Steering rod installation:
Install the smaller taper end of the rod toward the steering
knuckle and the taper hole of the steering arm. Make sure
the length of the rod 【A】 is correct, and the two visible
thread lengths【B】are approximately equal.
Steering rod
Rod length 【A】 418±1.5 mm
Steering System Technical Specifi cation
To Next Page
Loading...
