VEHICLE BODY AND FRAME
13 - 18
◆ Use a suitable tool to remove the 4 mounting screws
of the rear drive shaft and engine【J】Disconnect
the front drive shaft from the engine;
!
when assembling，use Thread glue to prevent the
screws from loosening and falling off .
◆ Use hose clamp pliers to remove the clamp【K】
to remove the radiator outlet pipe, And drain the
coolant;
◆ Use water pipe clamp pliers to remove the clamp
【L】to remove the water inlet pipe of the radiator,
And drain the coolant;
K
L
J
To Next Page
Loading...
