Segway SNARLER SGW570A6 2021 - Page 69

CRANKSHAFT / TRANSMISSION
CRANKSHAFT / TRANSMISSION
3-2-19
◆
Install:
1. Driven Bevel Gear Assembly
【
A
】
2. Shim,Driven Bevel Gear
【
D
】
3. Bolts M8×35
【
C
】
◆
Tighten:
Torque
Bolts
【
C
】
26 N·m (2.7 kgf·m, 20 ft·lb)
◆
Apply a non-permanent locking agent to the Bolts
【
C
】
TIPS
TIPS
Driven bevel gear backlash
Standard:0.15
~
0.25 mm
◆
Press and insert the bearings until they are bottomed.
Special Tool - Bearing Driver Set
Special Tool - Bearing Driver Set
【
B
】
Ball Bearing : 6305
◆
Install:
Bearing Frame Plate
【
A
】
Screw M8×25
【
C
】
◆
Tighten:
Torque
Screw M8×25
【
C
】
26 N·m (2.7 kgf·m, 20 ft·lb)
◆
Apply a non-permanent locking agent to the Screw
【
C
】
◆
Install:
1. Drive Bevel Gear Shaft,Reduction Driven Gear,Circlip
Combination
【
D
】
2. Drive Bevel Gear Shim
【
E
】
3. Drive Bevel Gear
【
F
】
4. Nut M22×1
【
G
】
◆
Tighten:
Torque
Nut M22×1
【
G
】
180 N·m (18.4 kgf·m, 133 ft·lb)
◆
Apply a non-permanent locking agent to the Nut
【
G
】
CAUTION
CAUTION
The Driving Bevel Gear
【
B
】
and Driven Bevel Gear
【
A
】
are machined at the factory in the assembled
state, so the Driving Bevel Gear and Driven Bevel Gear
must be replaced as a set.
D
D
A
A
B
B
C
C
C
C
B
B
A
A
G
G
F
F
E
E
D
D