Sekonic LITEMASTER PRO - Page 17

17
d) Remove the 3 screws securing the JR10-611 Optics Main Frame Assembly. (ZA344 M1.7×4 2pcs.
ZA348 M1.7×6 1pcs)
*ZA344 : The screw tightening torque is to be 7～9cNm (6.9～8.8kgcm)
*ZA348 : The screw tightening torque is to be 10～14cNm (9.8～13.7kgcm)
e) Remove the 3 screws securing JR106110 Rotating Stopper. (ZA375 M1.4×5 3pcs.)
*ZA375 : The screw tightening torque is to be 7～9cNm (6.9～8.8kgcm)
*When removing an Optics Cover / R Assembly, it warns against losing a Wiring Protection Part
(tube).
Cautions during assembly
J After putting an Optics Cover / R Assembly(JR10-613),
it is a screw stop about a Rotating Stopper(JR106110).
(ZA375 M1.4×5 3pcs)
*ZA344 : The screw tightening torque is
to be 7～9cNm (6.9～8.8kgcm)
*
Dowels are inserted in 2 locations on
the Rotary Stopper .
*It checks that the position of a Rotating
Stopper's stopper portion has been to
ZA344(M1.7×4)
1pcs
ZA348(M1.7×6)
2pcs
JR10-611
Optics Main Frame Assembly
JR10-613
Optics Cover / R Assembly
It takes care about Wire Harness and removes an
Optics Main Frame Assembly (JR10-611).
JR10-613
O
p
tics Cover / R Assembl
y
JR106110
Rotatin
g
Sto
pp
e
r
ZA375(M1.4×5)
3
p
cs
JR101240
Wiring Protection Part
（
tub
e
）
Chamfering of a
screw hole
Stopper portion
Dowel 2 places