LR1110
User Manual Rev.1.0
UM.LR1110.W.APP March 2020
19 of 130
Semtech
www.semtech.com
2.3.1 Power-On-Reset and Brown-Out Reset
If the battery voltage rises above the Power-On-Reset (POR) level, the LR1110 performs a restart. The LR1110 also features
a Brown-Out Reset (BRN), triggering a restart sequence if the battery voltage temporarily drops below the BRN level.
Both POR and BRN trigger a full restart of the internal firmware. The Status field of the Stat2 status variable indicates if a POR
or BRN occurred.
Please refer to 5.4 Power-On-Reset and Brown-Out-Reset for addition information on the POR and BRN.
2.3.2 NRESET
Putting the pin NRESET to low for at least 100 μs restarts the LR1110. The restart is equivalent to a Power-On Reset, and the
device will follow the same restart sequence.
2.3.3 Reboot Command
The command Reboot( ) triggers a restart of the LR1110 firmware.
• StayInBootLoader = 0 performs a firmware restart.
• StayInBootLoader = 3: the boot-loader will not execute the FW in flash, but will allow FW upgrades.
• Other values are RFU.
The configuration of the 32kHz clock will be kept on a Reboot. To modify the 32kHz clock configuration, the command
ConfigLFClock( ) shall be used.
2.4 Calibrations
During the startup sequence, the device firmware automatically launches the calibration of the low frequency and high
frequency RC oscillators, the PLL, the ADC, and the image rejection filter at 915MHz. At the end of the calibration procedure
the device is set in Standby RC mode.
In case of operation at another frequency, the image calibration procedure has to be restarted using the command
CalibImage( ).
In case of change of the device temperature, the RC oscillators calibrations has to be re-executed using the command
Calibrate( ).
Table 2-5: Reboot Command
Byte 0 1 2
Data from Host 0x01 0x18 StayInBootLoader
Data to Host Stat1 Stat2 IrqStatus (31:24)
To Next Page
Loading...