Semtech LR1110 - Getversion; Table 2-9: Calibparams Command; Table 2-10: Getversion Command; Table 2-11: Getversion Response

LR1110
User Manual Rev.1.0
UM.LR1110.W.APP March 2020
21 of 130
Semtech
www.semtech.com
With CalibParams defined as follows:
The command will operate in any mode of the device. At the end of the calibration procedure, the device returns to Standby
RC.
2.5 GetVersion
The command GetVersion() returns the version of the LR1110.
• HW Version is the version of the LR1110 hardware
• Use Case describes the main device features:
 0x01 = Transceiver
 0x02 = Modem
• FW Major + FW Minor is the version of the LR1110 internal firmware stored in flash memory.
Table 2-9: CalibParams Command
Bits (7:6) 5 4 3 2 1 0
Name RFU PLL_TX IMG ADC PLL HF_RC LF_RC
Table 2-10: GetVersion Command
Byte 0 1
Data from Host 0x01 0x01
Data to Host Stat1 Stat2
Table 2-11: GetVersion Response
Byte 0 1 2 3 4
Data from Host 0x00 0x00 0x00 0x00 0x00
Data to Host Stat1 HW Version Use Case FW Major FW Minor